Perlick 65666 Evaporator Fan Guard Plastic 4-5/16" DIA 3/4" High

• PERLICK:65666 ,PE65666

Step1: Disconnect power to refrigeration unit and ensure fan is fully stopped before installation.

Step2: Remove existing guard and clean mounting area for debris or ice.

Step3: Align guard with factory mounting holes and position correctly.

Step4: Secure with screws or clips, ensuring firm fit and no movement securely.

Step5: Verify fan clearance, restore power, and test airflow; wear protective gloves for safety.

• How to Replace Evaporator Fan Motor in Ice Machine?

  

  The Evaporator fan motor blows the air all over the evaporator coils and also through the refrigerator for cooling purposes. And it removes the heat in the circulating air. Commercial refrigeration applications use evaporator fan motors. Industrial refrigerator fan motors typically have one speed and are fractional horsepower in size and they move air across the evaporator coil. 

  Where is the evaporator fan motor in the freezer or refrigerator?

  The evaporator fan motor is at the back of the refrigerator or freezer, where a panel appears in the front. You need to remove the panel to check out the evaporator fan motor. To get through the panel, you need to remove all the shelves or racks that are placed inside the fridge.

  Now remove the shield and keep it aside from the freezer, in a safe place. You can find the Evaporator Fan right in front of you. Now, push the locking tabs and remove them slowly. Pull out the fan blade from the motor shaft. Now lift the 2 locking tabs on the fan motor, rotate the motor retainer in the clockwise direction, and remove it. Lift the motor from the mounting bracket. Now place the new motor in the same place, and put back the fan on top of it.

  Signs of bad fan motor:

  • The refrigerator is on, but the fan won't turn on.
  • After turning off the refrigerator, the fan continues to run.
  • The fan is turned on but spinning extremely slowly.
  • The fan only seldom runs.
  • When the fan is on, the condenser unit makes a rattling or buzzing sound.

  How do you test a refrigerator evaporator fan motor?

  To test the evaporator fan motor, you need to remove the Evaporator fan motor from the refrigerator and place it aside. To remove it follow the above steps that are mentioned in this blog. There will be two wires connected to the motor. You need to check those two wires.

  You need an OHM meter to perform this test. Put your needle on the OHM symbol. There are two tongs given to the meter, placed on the wires. If you receive the result as 97 ohms, then it is working and in a good condition. You can recheck it to confirm the correct results. If the readings are less than 97, it is not working properly and needs a replacement.

  If the evaporator fan malfunctions or the motor fails, the refrigerator won't chill effectively. The cool breeze is dispersed by the air, which serves as the primary source of cooling. You must replace the fan motor if it is broken or not operating properly.

  Fan motor replacement steps:

  • To replace it, unplug the power cord from the wall outlet so that there would be no electricity passage while working. Though switch

  • What maintenance is required for the Perlick 65666 Evaporator Fan Guard?

    Regularly inspect the evaporator fan guard for dust buildup, debris, or obstructions that may restrict airflow. Clean it gently with a soft brush or cloth to maintain proper ventilation. Ensure the guard remains securely mounted and undamaged. Disconnect power before servicing to prevent accidental damage.

  • What are common issues with the Perlick 65666 Evaporator Fan Guard?

    • Guard becomes loose or misaligned causing vibration noise.
    • Debris buildup restricting airflow through the evaporator section.
    • Physical damage such as bending or cracking from impact.
    • Misalignment leading to uneven fan operation or reduced cooling efficiency.